Description
1/2″ x 18″x 3/8” Masonry Hammer Drill Bit (Standard Chuck). Used for low pressure injection of Hyperflex polyurethane grout. Picture my not represent actual product.
1/2″ x 18″x 3/8” Masonry Hammer Drill Bit (Standard Chuck). Used for low pressure injection of Hyperflex polyurethane grout. Picture my not represent actual product.
$18.76
1/2″ x 18″x 3/8” Masonry Hammer Drill Bit (Standard Chuck). Used for low pressure injection of Hyperflex polyurethane grout. Picture my not represent actual product.
Weight | 1 lbs |
---|
HyperFlex is a highly versatile single component, pre-catalyzed hydrophobic polyurethane grout. Because it is pre-catalyzed there is none of the guesswork and expense of field mixing catalyst; simply adjust the temperature of the HyperFlex container to vary your reaction time. Since it is a hydrophobic material shrinking will not be an issue like it can be with hydrophilic materials. HyperFlex is NSF 61-2007 approved for contact with potable water.
Applications:
HyperFlex is a slower reacting product than our SealGuard II and works well in weeping or low flow leaks. The slower reaction and lower viscosity allows the material to travel further before reaction, allowing for better penetration and coverage within the leaking substrate. Once cured, HyperFlex will form a permanent, non-shrinking seal against further leaks.
Always read SDS before use.
Technical Data Sheet HyperFlex
Leaking Barrel Joint / Lateral Boot
Concrete Crack Injection / Precast Joint
Joining and Sealing Pre-Cast Concrete Sections using HyperFlex
Case Study: Ground Consolidation
Case Study: Pump Station Crack Injection
Case Study: Ground Stabilization Rotary Kiln
Case Study: Leaking Swimming Pool