Skip to Content
Exit

Archives

Tag Archive: water stop

  1. Simple Karst Remediation with Polyurethane Grout

    Leave a Comment

    Karstic formations can impose many challenges for mining and infrastructure. These underground passages often channel water into unwanted areas.  In this instance, a sinkhole opened in a stream bed, traveled through karst, and was emptying into a quarry.  To stop the water from traveling down the sink hole and to return the water to its normal flow, the polyurethane grout Hyperflex was used.

    Hyperflex is a single component hydrophobic polyurethane that reacts with water to produce a flexible foam.  Hyperflex was simply poured down the holes and was carried throughout the voids by the water. The raw Hyperflex reacted (foamed) with the presence of water. The foam then sealed off the leak paths.  Hyperflex is NSF/ANSI/CAN 61 approved for contact with potable water. Hyperflex is produced by SealGuard, Inc.

    karst repair

     

  2. Water Leaking through Old Mine Core Hole Stopped with Polyurethane

    Leave a Comment

    This underground mine, which is 1,100 feet below the surface, mined into a core hole taken from the surface.  The core hole was dumping significant amounts of ground water into the mine.  To stop the water inflow, a high-pressure probe and polyurethane grout was implemented. Grouting contractor Sub-Technical, Inc. used their specially designed probe to insert into the core hole.  The probe contains a port where polyurethane can then be injected to permanently seal it off. The polyurethane used was SealGuard II, which is manufactured by SealGuard, Inc.  SealGuard II is a dual component polyurethane grout that reacts in about 3 seconds to produce a rigid foam.  The cured foam has a 900-psi compression strength.