Sealguard II Leak Sealing Instructions

Step 1

Slide B (Nut) over A (mixer) - thread end first

Step 2

Drill 5/8" diameter hole to intersect leak path

Step 3

Tap A + B into hole until snug.

Prepare gun by pulling back plungers on E(dual caulk gun),insert D (tubes), while holding vertical, remove C from threaded end of tubes.

Step 4

Quickly align threads on D (tubes) with B (but) and tighten secure.

Step 5

Pump gun vigorously to expel grout to refusal or seal. If grout is washing out either pump slower or stop pumping and watch grout until it reacts halfway down A (mixer) then quickly give a pump to expel and repeat.

Tubes (D) must be 70⁰ F or warmer - Place in hot water to heat.

Related Files
	Roof Bolt Grouting
	Sealguard II Instructions