 |
 |
 |
 |
A - Mixer |
B - Nut |
C - End Caps D - Tubes |
E - Dual Caulk Gun |
 |
Slide Nut over Mixer (thread end first) |
 |
Drill 5/8” diameter hole to intersect leak path |
 |
tap A+B into hole until snug Prepare gun by pulling back plungers on E (dual caulk gun) insert D (tubes) while holding vertical, remove C from threaded end of tubes |
 |
Quickly align threads on D (tubes) with B (nut) and tighten to secure |
 |
Pump gun vigorousl to expel grout to refusal or seal. If grout is washing out either pump slower or stop pumping and watch grout until it reacts halfway down A (mixer) then quickly give a pump to expel and repeat. |
Tubes
(D) must be 70° F or warmer - Place in hot water to heat
